Clean home theater setups (especially setups with wall-mounted TVs) can require you to store your A/V in a remote place like a closet or another room. Since your IR remote controls require line-of-sight to control your equipment, you won't be able to use them unless you can send the signal to your equipment with an extender.

This IR Receiver is used with any combination of different IR Emitters and connecting blocks. The receiver is mounted on or near your TV. If you're looking to expand your existing IR Extension setup then this is what you're looking for. If you're starting from square one, check out our complete IR Receiver Kits.

Easy Install

The Keystone IR Receiver connects via 3-conductor cable (Such as Cat5e/6). Once everything is installed, all that will be visible is the wall plate.

Fits Standard Keystone Wall Plates

The Keystone IR Receiver fits all standard rectangular NEMA keystones. Making it easy to seamlessly integrate it into an existing setup. (Wall plates sold separate)

BlstIR Classic

BlastIR Classic

Works with BlastIR Classic. Simply terminate the corresponding wires to the Terminal block on the BlastIR Classic directly. No additional adapters needed.

Troubleshooting

Troubleshooting IR Repeaters

These steps can help you troubleshoot any IR equipment to determine any possible problems.

Specifications

Receiver Frequency Range: 34 KHz to 60 KHz
Transmit Frequency Range: 38 KHz to 56 KHz
Range: 40ft @ 38 KHz, 25ft @ 56 KHz
Power: DC 12V, 30 mA max
Dimensions: 39.2L x 19.3W x 24.3H mm

Keystone Jacks and Wallplates

Sewell Keystone IR Receiver – In-Wall IR Receiver Module for IR Repeater Systems